SKR 1.4 – Basic Switch Endstop



Explains basic switch endstop sensor and how to enable and load correctly in Marlin Firmware on SKR 1.4 motherboard.

One Time Tips, You Can PayPal Me:

Hardware:
Hardware:
1 – BigTreeTech SKR 1.4
1 – USB Cable
1 – Switch Endstop

Amazon Affiliate Links:
(SKR v1.4)
(Switch Endstop)
(Acer Nitro 5 Laptop)

Documentation and Firmware

Software:
Marlin Firmware 2.0.x

Pronterface:

Nguồn: https://dienthoaivinsmart.com

Xem thêm bài viết khác: https://dienthoaivinsmart.com/ung-dung

  • HELP!!! #error "Z2_USE_ENDSTOP has been assigned to a nonexistent endstop!" ON SKR1.4 TURBO

    mario marinez May 18, 2020 7:37 am Reply
  • Hello, I have a creality cr 10 with only two connectors, but I suppose that the 5V only serves to power the led. My concern is that after following the tutorial, the machine completely ignores the switch. Do you have a solution, thanks in advance. On the other hand, ponterface clearly sees the changes of state.

    ERAGONTH May 18, 2020 7:37 am Reply
  • So I have an Ender 3 and my end stops have a 2 wired plug.. yet the skr 1.4 have 3 pins.. should I use the +5v and ground then ?

    Michael van Dijk May 18, 2020 7:37 am Reply
  • Can't wait for the BLTouch setup, I'm having some trouble with this.

    DutchDudeTv May 18, 2020 7:37 am Reply
  • Hey Edward please write me on instagram: airgunfun_de or facebook: Rene We because i have a big problem with my skr board and really NO ONE could help me 🙁 perhaps yo have a idea. so pleas contact me :'(

    AirGunFun May 18, 2020 7:37 am Reply
  • am I correct that the btt endstops have included resistors and condensators, ? so more meant for replacement of for newly builds ? technically you could use build in pullup/down ? (not sure if SKR1.4 has that option)

    patrick maartense May 18, 2020 7:37 am Reply

Leave a Reply

Your email address will not be published. Required fields are marked *